EDGE
Ultrasonic Dog Trainer
(Model: UT01)
DogCare EDGE Ultrasonic Dog Trainer (Model: UT01) FAQ’s
1.
How do I charge the device?
a.
Using the USB cable, attach one end to a power source and plug the other end bottom
of the ultrasonic dog trainer.
b.
When the charging cable is correctly connected, the device will vibrate slightly and the
status light will turn red.
c.
When the status light turns green it indicates that the device is fully charged.
d.
It usually takes about 4 to 5 hours to fully charge.
Typically, after it is charged, you can
use it for four months without having to recharge it.
e.
If the power is ON while charging, the ultrasonic trainer will work normally.
2.
Can you tell if the battery is low/empty?
a.
When the battery is getting low the light will flash red every 5 seconds, indicating that
the device should be charged soon. When the low battery alert is on the device can still
work normally.
b.
When the battery is empty the status light will no longer light up. Pressing any button
will result in the status light flashing red 4 times quickly. At this time the device can not
work normally and can only be used after charging.
c.
The ultrasonic trainer uses a lithium battery which requires routine recharging to
achieve maximum battery life span. In case the device is unused for and extended
period of time you should be sure to fully charge the battery every 3 months to maintain
battery life.
3.
How do I turn ON the ultrasonic trainer?
a.
Push the ON/OFF switch to the ON position.
b.
The device will vibrate slightly two times when turning on, and the status light will be
green and flash twice.
c.
When ON, the status light will flash green every 5 seconds.
4.
How do I turn the ultrasonic trainer OFF?
a.
Push the ON/OFF switch down to the OFF position.
b.
When the device is off. All buttons will be invalid.
