Dodge HSCXT 305E, Инструкция по эксплуатации

Страница: 1 / 16

1
Single Reduction Screw Conveyor and
Hydroil Screw Conveyor Drive
Instruction Manual
SCXT / HSCXT 305E
SCXT / HSCXT 405E
SCXT / HSCXT 505E
SCXT / 605E
SCXT / 705E
These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of
printing. Please see dodgeindustrial.com for updated instruction manuals.
WARNING: To ensure the drive is not unexpectedly started, turn off and
lock-out or tag power source before proceeding. Failure to observe these
precautions could result in bodily injury.
WARNING: Because of the possible danger to person(s) or property
from accidents which may result from the improper use of products,
it is important that correct procedures be followed. Products must be
used in accordance with the engineering information specified in the
catalog. Proper installation, maintenance and operation procedures
must be observed. The instructions in the instruction manuals must
be followed. Inspections should be made as necessary to assure
safe operation under prevailing conditions. Proper guards and other
suitable safety devices or procedures as may be desirable or as may
be specified in safety codes should be provided, and are neither
provided by Dodge
®
nor are the responsibility of Dodge. This unit and
its associated equipment must be installed, adjusted and maintained
by qualified personnel who are familiar with the construction and
operation of all equipment in the system and the potential hazards
involved. When risk to persons or property may be involved, a holding
device must be an integral part of the driven equipment beyond the
speed reducer output shaft.
WARNING: All products over 25 kg (55 lbs) are noted on the shipping
package. Proper lifting practices are required for these products.
Figure 1 - SCXT Assembly
ASSEMBLY
NOTE: A screw conveyor drive consists of three
sub-assemblies listed below.
1. Reducer – Includes speed reducer, shaft retainer, retainer bolt
and lockwasher
2. Adapter Assembly – Includes adapter bolts, lockwashers, a
lip type seal and a seal retaining ring
3. Drive Shaft – Includes shaft and key
Make certain none of the parts have been damaged in shipment.
Any shipping damage should be promptly reported to the
carrier. Read all instructions in this manual before attempting to
assemble or install the screw conveyor drive. It is important that
assembly be performed in the following sequence and that each
step be completed before continuing to the next.
NOTE: This reducer is compatible with the Dodge sensor
that can be installed in the adapter plug labeled “smart
sensor”. The plug and sensor can be moved to different
locations as required by mounting position.
FIGURE 1: SCXT ASSEMBLY
DRIVESHAFT
SEAL
RETAINING
RING
LIP SEAL OR
BRAIDED SEALS
ADAPTER
SCREW CONVEYOR DRIVE
SPEED REDUCER
ADAPTER BOLT
AND LOCK WASHER
DRIVESHAFT
KEY
DRIVESHAFT
RETAINER
RETAINER BOLT
AND LOCKWASHER