WARNING!
To avoid serious injury or death:
• Do not insert any objects into the recep-
tacles.
• Do not touch with wet hands.
• Close the lid when not in use.
• If this outlet is mishandled, it may cause
an electric shock and failure.
ROOF LUGGAGE RACK — IF
EQUIPPED
The crossbars and side rails are designed to
carry weight on vehicles equipped with a lug-
gage rack.
The load must not exceed 150 lbs
(68 kg), and should be uniformly distributed
over the luggage rack crossbars.
The crossbars on your vehicle are delivered
stowed within the roof rack side rails. Crossbars
should always be used whenever cargo is placed
on the roof rack. Check the straps frequently to
be sure that the load remains securely attached.
The roof rack does not increase the total load
carrying capacity of the vehicle. Be sure the
total load of cargo inside the vehicle plus that on
the external rack does not exceed the maximum
vehicle load capacity.
Deploying The Crossbars
1. Starting with one crossbar, completely
loosen the thumb screws at both ends of the
crossbar.
NOTE:
The thumb screws cannot be fully removed.
2. Remove the crossbar from the stowed posi-
tion by sliding the crossbar towards the cen-
ter of the roof. Repeat with crossbar on the
opposite side.
CAUTION!
Use care when removing and handling the
crossbars to prevent damage to the vehicle.
3. Starting with one crossbar, bend down the
pivot supports at each end.
4. Position the crossbars across the roof mak-
ing sure the letters on the crossbars align
with the matching letters on the side rail.
5. Slide the cross bar into to the deploy position
by moving it towards the matching letter in
the side rail. Be sure the crossbar is fully
deployed with the crossbar pushed as far
into the slot as possible. Once the crossbar is
in place, tighten both thumb screws
completely.
6. Deploy and tighten the second crossbar to
complete the deployment of the crossbars.
Stowing The Crossbars
1. Starting with one crossbar, completely
loosen the thumb screws at both ends. Slide
the crossbar away from the matching letter
to remove it from the deployed position.
Repeat with the other crossbar.
CAUTION!
Use care when removing and handling the
crossbars to prevent damage to the vehicle.
2. Starting with the one crossbar, bend up the
pivot supports at each end.
65
Содержание DURANGO 2019
