Dodge Charger SRT 392 2017, Руководство по эксплуатации

Страница: 70 / 576

NOTE:
Your key fobs can be unlinked from your
memory settings by pushing the set (S) button,
and within 10 seconds push the unlock button
on the key fob.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the
vehicle is not in PARK, a message will display in
the instrument cluster display.
To recall the memory settings for driver 1, push
memory button (1) on the driver’s door or the
unlock button on the key fob linked to memory
position 1.
NOTE:
If the vehicle is equipped with Passive Entry, the
memory settings will be recalled with a Passive
Entry Unlock into the driver’s door using the key
fob linked to position 1.
To recall the memory setting for driver 2, push
memory button (2) on the driver’s door or the
unlock button on the key fob linked to memory
position 2.
NOTE:
If the vehicle is equipped with Passive Entry, the
memory settings will be recalled with a Passive
Entry Unlock into the driver’s door using the key
fob linked to position 2.
A recall can be cancelled by pushing any of the
memory buttons (S, 1, or 2) on the driver’s door
during a recall. When a recall is cancelled, the
driver’s seat or power tilt and telescopic steering
column (if equipped) stop moving. A delay of
one second will occur before another recall can
be selected.
Easy Entry/Exit Seat
This feature provides automatic driver’s seat
positioning to enhance driver mobility when en-
tering and exiting the vehicle.
The distance the driver’s seat moves depends
on where you have the driver’s seat positioned
when you cycle the vehicle’s ignition to the OFF
position.
•
When you cycle the vehicle’s ignition to the
OFF position, the driver’s seat will move
about 2.4 inches (60 mm) rearward if the
driver’s seat position is greater than or equal
to 2.7 inches (67.7 mm) forward of the rear
stop. The seat will return to its previously set
position when you cycle the vehicle’s ignition
to the ACC or RUN position.
•
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to the
driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later dis-
abled) through the programmable features in
the Uconnect system. Refer to “Uconnect
Settings/Customer Programmable Features” in
“Understanding Your Instrument Panel” for fur-
ther information.
TO OPEN AND CLOSE THE
HOOD
Two latches must be released to open the hood.
1. Pull the hood release lever located under the
left side of the instrument panel.
2. Move to the front of the vehicle.
Hood Release Lever
67