Dodge charger 2017, Руководство пользователя

Страница: 85 / 276

BLIND SPOT MONITORING
The Blind Spot Monitoring (BSM) system uses two radar sensors, located inside the rear
bumper fascia, to detect highway licensable vehicles (automobiles, trucks, motorcycles
etc.) that enter the blind spot zones from the rear/front/side of the vehicle.
The BSM detection zone covers approximately one lane width on both sides of the vehicle
12 ft (3.8 m). The zone length starts at the outside rear view mirror and extends
approximately 10 ft (3 m) beyond the rear bumper of the vehicle. The BSM system
monitors the detection zones on both sides of the vehicle when the vehicle speed reaches
approximately 6 mph (10 km/h) or higher and will alert the driver of vehicles in these
areas.
When the vehicle is started, the BSM warn-
ing light will momentarily illuminate in both
outside rear view mirrors to let the driver
know that the system is operational. The
BSM system sensors operate when the ve-
hicle is in any forward gear or REVERSE,
and enters standby mode when the vehicle
is in PARK.
The BSM warning light, located in the outside mirrors, will illuminate if a vehicle moves
into a blind spot zone.
The BSM system can also be configured to
sound an audible (chime) alert and mute
the radio to notify you of objects that have
entered the detection zones.
Rear Cross Path (RCP)
The Rear Cross Path (RCP) feature is intended to aid the driver when backing out of
parking spaces where the vision of oncoming vehicles may be blocked. Proceed slowly and
cautiously out of the parking space until the rear end of the vehicle is exposed. The RCP
system will then have a clear view of the cross traffic and if an oncoming vehicle is
detected, will alert the driver. When RCP is on and the vehicle is in REVERSE, the driver
is alerted using both the visual and audible alarms, including reducing the radio volume.
Rear Detection Zones
Blind Spot Mirror
O P E R A T I N G Y O U R V E H I C L E
83