2500/3500 Series Trucks
1. Tighten the jack all the way down by turning the jack turn-screw clockwise until
the jack is snug.
2. Position the jack and tools into bracket assembly. Make sure the lug wrench is under
the jack near the jack turn-screw. Snap tools into bracket assembly clips. Install the
jack into bracket assembly and turn screw until jack is snug into bracket assembly.
3. Place the jack and tool bracket assembly in the storage position holding the jack
by the jack turn-screw, slip the jack and tools under the seat so that the bottom
slot engages into the fastener on the floor.
NOTE:
Ensure that the jack and tool bracket
assembly slides into the front hold down
location.
4. Turn the wing bolt clockwise to secure
to the floor pan. Reinstall the plastic
cover.
Hub Caps/Wheel Covers
• The hub caps must be removed before raising the vehicle off the ground.
• For single rear-wheel (SRW) models, use the blade on the end of the lug wrench
to pry the hub cap off. Insert the blade end into the pry-off notch and carefully pop
off the hub cap with a back-and-forth motion.
• On models with dual rear wheels (DRW), you must first remove the hub caps. The jack
handle driver has a hook at one end that will fit in the pry off notch of the rear hub
caps. Position the hook and pull out on the ratchet firmly. The hub cap should pop off.
The wheel skins can now be removed. For the front hub cap use the blade on the end
of the lug wrench to pry the caps off. The wheel skin can now be removed.
• You must use the flat end of the lug wrench to pry off the wheel skins. Insert the
flat tip completely and using a back-and-forth motion, loosen the wheel skin.
Repeat this procedure around the tire until the skin pops off.
• Replace the wheel skins first using a rubber mallet. When replacing the hub caps, tilt
the cap retainer over the lug nut bolt circle and strike the high side down with a rubber
mallet. Be sure that the hub caps and wheel skins are firmly seated around the wheel.
Floor Fastener Location
W H A T T O D O I N E M E R G E N C I E S
221