To Lock The Vehicle’s Doors:
With a valid Keyless Enter-N-Go™ Key Fob transmitter within 5 ft (1.5 m) of the driver
or passenger front door handles, push door handle LOCK button to lock all doors.
Do NOT grab the door handle, when pushing the door handle lock button. This could
unlock the door(s).
NOTE:
• After pushing the door handle LOCK button, you must wait two seconds before you
can lock or unlock the doors, using either Passive Entry door handle. This is done
to allow you to check if the vehicle is locked by pulling the door handle without the
vehicle reacting and unlocking.
• The Passive Entry system will not operate if the RKE transmitter battery is dead.
The vehicle doors can also be locked by using the RKE transmitter lock button or the
lock button located on the vehicles interior door panel.
Engine Starting/Stopping
Starting
With a valid Keyless Enter-N-Go™ Key
Fob inside the vehicle:
1. Shift the transmission into PARK.
2. While pushing the brake pedal, push
the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically
after 10 seconds.
3. To stop the cranking of the engine prior
to the engine starting, push the button
again.
Push The Button To Lock
Do NOT Grab The Handle When Locking
Start/Stop Button
G E T T I N G S T A R T E D
14
