Docomo STYLE Series P-03A, Инструкция по эксплуатации

Страница: 46 / 581

44
Befo
re
Usi
ng
th
e Ha
nd
set
1
Press and hold
h
for at least one
second.
After the Wake-up display (see page 104) is displayed,
the Stand-by display appears.
p If you have stored many Phonebook entries or mail
messages, it may take a while for the display to appear.
p
If Set Time is set, the current date and time are shown.
p When “ ” is displayed, the FOMA terminal is out of
the service area or in the place where the radio waves
do not reach. Move to a location where “
”
disappears.
p If “Starting system Wait a minute” is displayed when
you turn on the power, wait for a while and then
proceed.
Enter the four- to eight-digit Terminal Security Code after turning on the power. When
you enter the correct Terminal Security Code, the Stand-by display appears. If you enter
the incorrect Terminal Security Code five times in succession, the power turns off.
(However, you can turn on the power again.)
Enter the four- to eight-digit PIN1 code after you turn on the power. When you enter the
correct PIN1 code, the Stand-by display appears. See page 116 for PIN1 code.
Enter the four- to eight-digit PIN2 code after you turn on the power. When you enter the
correct PIN2 code, the Stand-by display appears. If you press
r
or
h
without
entering the correct PIN2 code, “Auto reset setting” is set to “OFF” and the Stand-by
display appears. See page 116 for PIN2 code.
<Power ON/OFF>
Turning Power ON/OFF
Turn Power On
Stand-by display
When your UIM is replaced (except during Omakase Lock)
When “PIN1 code entry set” of “UIM setting” is set to “ON”
When “Auto reset setting” of “Notice call cost” is set to “ON”
(except during Omakase Lock)
The mail messages “Welcome デコメアニメ
(Welcome Decome-Anime )” and “
緊急速報「エリアメール」のご案内
(Introduction of Early Warning “Area Mail”)” have been saved by default. Press
+ O o
twice
or perform step 1 of “Display Mail from Inbox” on page 153 to show the Inbox list.
1
Press and hold
h
for at least two seconds.
The exit display appears and the power turns off.
p You cannot turn on the power immediately after turning off the power. Wait a few
seconds.
1
m
設定／サービス (Set./Service)
ディスプレイ (Display) バイリンガル (Select language)
Japanese ( 日本語 ) or English ( 英語 )
p The following functions are different between Japanese display and English display:
Check Welcome Mail
Information
p
Each entry display appears in the order of “PIN1 code”
→
“Terminal Security Code”
→ “PIN2 code”.
Turn Power Off
+ m - 1 - 5
<Select Language>
Switching to English Display
Functions Japanese English
Info Notice Setting 電子音 (Electrical tone)
ボイス
(Voice)
OFF
ON
Not available
OFF
“Clock” of Display Setting
→ “Stand-by clock/Stand-by clock Wide”
→ “Day of week”
Available Not available
使いかたナビ (Guide) Available Not available
Voice Guidance Available Not available
Information
p When you insert the UIM, the “ バイリンガル (Select language)” setting is stored on
the UIM.