Docomo Style L-03B, Инструкция по эксплуатации

Страница: 126 / 139

27
AT Command List
The following commands can be used with the L-03B modem.
• The following commands can be entered but are invalid commands that will not work.
- AT (input only AT)
- ATS0 (set number of rings until the FOMA terminal automatically answers a call)
- ATS6 (set time for pause until dialing)
- ATS8 (set time for pause by comma dial)
- ATS10 (set time for delay until automatic disconnection)
AT Commands Overview Parameters/Descriptions
Command
Examples
A/ Repeat the last AT
command executed.
A carriage return (CR)
does not need to be
entered after inputting
this command. − A/
OK
AT%V Display the version of
the FOMA terminal. − AT%V
L03B-
XXXXXXXXX-
XXXXX- XXX-XX-
2008-DCM-JP
X [XXX XX
2008 XX:XX:XX]
OK
AT&C<n> Set the operating
conditions of the circuit
CD signals for DTE. n=0 : Always keep circuit CD
signal ON.
n=1 : CD changes depending
on the other party
modem carrier (default)
AT&C1
OK
AT&D<n> Set the operation
performed when a circuit
ER signal received from
DTE is switched from
ON to OFF. n=0 : Ignore ER signals
(Always regard as ON).
n=2 : When ER signals
are turned off by
disconnecting, the PC
switches over to the
offl
ine command mode
(default)
AT&D2
OK
AT&F<n> Restore all registers
to their defaults. If this
command is entered
during communication,
the line will be
disconnected. Only n=0 can be set (optional) −
AT&W<n> Store the current
setting value to the
FOMA terminal. Only n=0 can be set (optional) −
AT*DANTE Display the signal
strength (number of
antenna bars) of the
FOMA terminal. Result format:
*DANTE:<m>
m=0 : Out of service area
m=1 : State of 0 or 1 antenna
bar displayed
m=2 : State of 2 antenna bars
displayed
m=3 : State of 3 antenna bars
displayed
AT*DANTE
*DANTE:3
OK
Continue on the next page