Docomo P-06b, Инструкция по эксплуатации

Страница: 21 / 171

19
Intr
oduction
⿠
Before using the FOMA terminal, make sure that you attach the back
cover firmly after tightly closing the connector terminal cover and inner
cover. If there is any small particles (fine fibers, hair or grains of sand)
between the covers and unit, water could find its way inside the unit.
When attaching the back cover after closing the connector terminal
cover and inner cover, ensure that there is no particles or dirt on or
around these parts (especially the packing).
⿠
Ensure that the connector terminal cover, inner cover and back cover
are closed tightly and that none of these covers is askew. If the covers
are not closed tightly, water could find its way inside the FOMA terminal.
⿠
To enhance the waterproof performance, you need to replace parts
without fail once two years regardless whether any abnormality with
the FOMA terminal is found or not. You are charged for replacement
of parts. Take your FOMA terminal to a repair counter specified by
DOCOMO.
■
Opening/Closing the Connector Terminal Cover
■ Opening the connector terminal cover
①
Hook your finger over the groove, pull
out the cover to direction A, and turn it as
direction B.
■
Closing the connector terminal cover
①
Align the connector terminal cover in
parallel with the FOMA terminal, and while
holding its base firmly, push it into place.
②
Ensure that no float is found with the
connector terminal cover as a whole.
Hook
Base
Important Issues at Start of Using
■
Removing/Attaching the Back Cover
■
Removing the back cover
①
While pushing down on the area
about 3 cm from the connector
terminal cover in direction A,
slide the back cover (by 2 mm or
more) in direction B to unlock and
remove it.
② Using the projections on the inner
cover, pull up the inner cover in the
direction shown by the arrow and
open it until it will go no further.
・
The inner cover can be firmly closed
for maintaining waterproofness.
Opening the cover forcibly may
injure your nails or fingers.
■
Attaching the back cover
①
Fit the claws at the left, right and bottom sides of the inner cover
into the corresponding indentations, and push the cover into place.
②
Push the eight
●
marks printed
on the sticker of the inner cover,
and ensure that no float is found
anywhere on the back cover.
Connector terminal cover
Projection
Claw
Packing
Rear surface of inner cover
Approx. 3 cm