Docomo FOMA P706ie, Инструкция по эксплуатации, Страница: 563 / 577

46
AT commands are used to specify and modify the
functions of the FOMA phone on the personal computer.
※ The following abbreviations are used in the AT command list:
[AT]: Commands which are available at the FOMA P706ie
Command Port.
[M]: Commands which are available in the FOMA P706ie
(modem).
[&F]: Commands whose settings are initialized by the AT&F
command.
[&W]: Commands whose settings are saved by the AT&W
command. The set value can be recalled by the ATZ
command.
To enter an AT command, use the terminal mode display
of the communication software. Be sure to enter
half-pitch alphanumeric characters.
≥
Entry example
≥
You need to enter an AT command on one line, including a
parameter (digits and symbols) which follows the command.
There are following two methods of switching the FOMA
phone between the online data mode and online
command mode:
・ Enter the “+++” command or enter the code specified
in the “S2” register.
・
Set the ER signal of the RS-232C
※
off when “AT&D1”
is set.
≥
To switch the online command mode to the online data mode, enter
“ATO
”.
※ The RS-232C signal line, which is emulated via the USB interface, is
controlled by a communication application.
Using AT Command
AT Command
Information
≥
When you make a call from an external device or make an AT
command call, the call is made from Number A in A Mode or Dual Mode
of 2in1, and the call is made from Number B in B Mode of 2in1.
Entry Format of AT Command
Information
≥
The terminal mode enables you to operate a personal computer as one
communication terminal. Using this mode, you can send characters you
have entered from the keyboard to a line connected to the
communication port.
Switch between Online Data Mode and
Online Command Mode
ATD
¢
99
¢¢¢
1#
RETURN mark
Parameter
Command
■ Saving the setting contents
Please be careful that the setting contents with AT commands are
initialized when the FOMA phone is turned off and on or the external
device is removed, except for the access point name (APN) setting with
the AT+CGDCONT command, QoS setting with the AT+CGEQMIN or
AT+CGEQREQ command, incoming call acceptance/rejection setting
with the AT
¢
DGAPL, AT
¢
DGARL, or AT
¢
DGANSM command, phone
number notification/no notification setting (for packet communication)
with the AT
¢
DGPIR command and caller ID notification restriction setting
with the AT+CLIR command. For commands with [&W], you can enter
“AT&W
” (after setting) to save the setting contents and other set
values with [&W] at the same time. If necessary, you can restore these
set values by entering in “ATZ
” even after the power is turned off and
on.