Docomo FOMA P706ie, Инструкция по эксплуатации, Страница: 46 / 577

44
Befo
re
Usi
n
g
th
e Ha
nd
set
The mail message “Welcome P706ie ” has been saved by default. Press
+ O o
twice or perform the operation of “Display Mail from Inbox” on page 199 to show the mail
message.
1
Press and hold
h
for at least two seconds.
The exit display appears and the power turns off.
≥
You cannot turn on the power immediately after turning off the power. Wait a few
seconds.
1
m
1
設定
(Settings)
1
ディスプレイ
(Display)
1
バイリンガル
(Select language)
1
Japanese (
日本語
) or English (
英語
)
≥
The following functions are different between Japanese display and English
display:
Check Welcome Mail
Information
≥
Each entry display appears in the order of “PIN1 code” → “Terminal Security Code”
→ “PIN2 code”.
Turn Power Off
+ m - 1 - 5
<Select Language>
Switching to English
Functions Japanese English
Info Notice Setting 電子音 (Electrical tone)
ボイス
(Voice)
OFF
ON
Not available
OFF
“Clock” of Display Setting
→ “Day of week”
Available Not available
使いかたナビ (Guide) Available Not available
Voice Guidance Available Not available
Information
≥
When you insert the UIM, the “
バイリンガル
(Select language)” setting is stored on
the UIM.
If the date and time, Terminal Security Code, Keypad Sound, or Character
Size is not set, the Initial Setting display appears when you turn on the
power. You can set the initial settings also from each menu function
separately.
1
Turn on the power
1
YES
≥
When the display for entering your Terminal Security
Code, PIN1 code, or PIN2 code appears, follow the
operation on page 43.
2
Set the date and time.
You can select “Auto time adjust ON” or “Auto time adjust OFF” for setting the time.
(See page 45)
3
Set your Terminal Security Code.
You can set your Terminal Security Code required for setting functions.
(See page 116)
1. Enter “0000”
1
Enter your new Terminal Security Code (four to eight digits)
1
YES
4
Set Keypad Sound.
You can set whether to make a keypad sound. (See page 94)
5
Set the size of characters.
You can set the size of characters on the display at a time. (See page 111)
<Initial Setting>
Executing Initial Settings
Information
≥
When an unset function is found, the Initial Setting display for the unset function
appears each time you turn on the power.
≥
The completed settings are valid even when total setting is interrupted by an incoming
call or canceled by pressing
- h
or
- r
midway.