Before using the terminal
54
◆
Unlocking screen lock
1
During sleep mode,
P
2
On the screen, tap
The lock is canceled.
･
Depending on the setting of [Security unlock
preference] (
P145), authentication is required after
swiping on the lock screen.
･
Tap
on the lock screen to activate the camera.
･
Tap
on the lock screen to activate the
しゃべってコン
シェル
(Shabette concier).
✔
INFORMATION
･
By default, numbers of missed calls and unread docomo
mails are shown even when lock screen is displayed.
･
By default, the lock screen goes into the sleep mode after
approximately 10 seconds.
◆
Slide-in function
By default, you can call out Slide-in launcher and Capture &
Draw/Highlight & Copy by sliding your finger from the slide
spot (start point for sliding) at the corner of the screen.
･
For information about the settings of the Slide-in function,
refer to "Slide-in function".
❖
Slide-in launcher
Activate an application from a shortcut saved in Slide-in
launcher.
1
Slide your finger from the slide spot to the
center of the screen, then release the finger at
a shortcut in Slide-in launcher
･
By default, Slide-in launcher is set in the slide spot at the
lower left of the screen.
･
You can set the Slide-in function by releasing your
finger at the position of
, which is called up at the
same time as the Slide-in launcher.
2
Perform target operations
"
ひつじのしつじくん
®
(Butler Sheep)"
©
NTT DOCOMO
Содержание arrowsbe F-05J
Страница 1: ...F 05J INSTRUCTION MANUAL 17 5...
