DNP Imagingcomm America Corporation
53
Setting Up the WPS Pro System
WPS Pro User Guide
Setting Up the WPS Pro System
Note
Be sure you plug in and turn ON the printer before you connect to the WPS Pro device. When WPS
Pro starts, it automatically configures the network for the connected printers. If you change printer
connections, shut down your device and then restart it. See “Turning Off the WPS Pro” on page 57
to properly reboot your device.
1.
Turn ON your printer(s).
Attention
If your printer(s) are NOT powered ON, they will not be detected when connected to the WPS Pro device.
2.
Plug the power cable into a properly grounded power outlet and into the WPS Pro power port on the back of the
device.
Figure 2. WPS Pro Power Port
3.
Connect the printer(s) to the USB ports on the back and side of the WPS Pro device. If you are connecting only one (1)
printer to the device, connect the printer USB cable to the lower USB port on the back of the device.
Figure 3. WPS Pro lower USB
WPS Pro can connect to two (2) DNP printers simultaneously.
You must connect to the lower USB port on the back of
the device first
. The WPS Pro device can be connected to the following DNP printers: DS40, DS80, DS620A/DS620,
DS820A/DS820, RX1, and RX1-HS.
