Installation and User Manual
3. Using ProFusion D
3.1 – Turning on ProFusion D
To turn on ProFusion D, press the Standby button once. The green LED power light
in the lower right corner of the front panel will illuminate and ProFusion D will beep
twice on the same note with approximately two seconds between beeps (the beeps
are not broadcast through the audio outputs). If ProFusion D beeps in any other
way, please refer to
Appendix A: Troubleshooting and Error Codes
or contact your
customer service center (please refer to
Appendix B: Customer Support).
Always ensure that the CD-drive tray is closed
except when loading or changing CDs. To close
the CD-drive tray, press the CD-eject button
located on the lower right corner of the CD-drive.
3.2 – Beginning Music Playback
At any time after the Standby button has been pressed to turn ProFusion D on, press
the CD-eject button on the CD drive. Place a valid ProFusion D disc (label side up)
into the tray.
Always use the CD-eject button to close the tray.
After a few seconds,
you will hear the CD drive begin to spin. Music will begin playing approximately 15
seconds after the CD tray is closed.
Only ProFusion D discs provided by DMX MUSIC
will play in this device. Commercial audio CDs,
software, DVD, or any other non-DMX produced
discs will not function. Placing a non-DMX
produced disc into the drive will cause the drive
to eject the disc after a few seconds.
3.3 – Changing Output Volume
ProFusion D does not feature volume control. To change the level of the volume,
please adjust the amplification equipment.
3.4 - Changing ProFusion D Discs
While ProFusion D is playing music, press the CD-eject button. The CD tray will eject
and within a few seconds, the music will fade. Place a different ProFusion D disc into
the tray. A
lways use the CD-eject button to open or close the tray.
After a few
seconds, you will hear the CD drive begin to spin. Music will begin playing
approximately 15 seconds after the CD tray is closed.
Page 9 of 14
