X1 SERIES ELEVATOR CONTROLLER INSTALLATION & PROGRAMMING GUIDE | DIGITAL MONITORING PRODUCTS
3
STEP 1: MOUNT THE ELEVATOR CONTROLLER
PRE-INSTALLATION
Warning:
The X1 Elevator Controller cannot be installed without being in contact with the elevator
service company� This guide covers only what the elevator control installer will be able to do�
Optional X1 Elevator Expansion
If not installing additional elevator
modules, skip to Step 2
Connect a Card
Reader
�
Mount the Enclosure
The metal enclosure for the X1 Elevator
Expansion Module must be mounted to
a wall, backboard, or other flat surface
within 3 feet of the first X1 Elevator
Controller� It is not necessary to remove
the PCB when installing the enclosure�
0 1
2
3
4
5
6
7
8
9
First X1 Elevator Module
X1 Elevator Controller
12 V Battery
+ -
-
+
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
X1 Elevator Controller
X1 Elevator Expansion
Mounting Holes
Set the Address
The X1 Elevator Control Module has a 1 through 9 addressable rotary dial that is factory
defaulted to 1� Additional modules need to be addressed in sequence�
0 1
2
3
4
5
6
7
8
9
First X1 Elevator Module
X1 Elevator Controller
12 V Battery
+ -
-
+
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
X1 Elevator Controller
X1 Elevator Expansion
0 1
2
3
4
5
6
7
8
9
First X1 Elevator Module
X1 Elevator Controller
12 V Battery
+ -
-
+
0 1
2
3
4
5
6
7
8
9
Second X1 Elevator Module
X1 Elevator Controller
X1 Elevator Expansion
Wire the Expansion Module to the First Module
Use the included 4-position harness
to connect the top connector on the
second elevator control module to the
bottom connector on the first elevator
control module�
X1 Elevator Controller
The metal enclosure for the X1 Series Elevator Controller must be mounted directly to a wall,
backboard, or other flat surface in a secure, dry place to protect the elevator controller from damage� It
is not necessary to remove the PCBs when installing the enclosure� Address the rotary on the elevator
control module to 1�
If not installing an expansion configuration of any kind, skip to
Connect a Card Reader
�
a
b
