DMP Electronics Thinline 7463, Инструкция по установке и программированию

Страница: 27 / 40

Digital Monitoring Products, Inc. | 7400 Series Thinline™ Keypad Installation and Programming Guide 23
TEST THE KEYPAD
Test the keypad to ensure alarm backlighting abd individual shortcut keys. To begin testing,
access the Installer Options menu. Hold down the
back arrow
and
CMD
keys at the same
time until SET BRIGHTNESS displays. Enter 3577 and press CMD .
Keypad Diagnostics
Press the select key under KPD DIAG . The keypad lights all
display segments and illuminates the keyboard in red. The
display backlighting then changes to green. The keypad
alternates between these two states for approximately two
minutes. Press CMD at any time to begin testing individual keys.
Test Individual Keys
The keypad lights in red, and the display changes to
PRESS KEY TO TEST . This option tests each key on the keyboard
to ensure it is operating properly. Press and hold each key for
two seconds. The key number being held appears in the display.
Verify the correct number displays before testing the next key.
Zones Okay
This is a read-only menu item.
Save Programming
Select
STOP
to save and exit programming.
KPD
KPD
OPT DIAG STOP
PRESS KEY TO
TEST
ZONE 1: OK ZONE 2: OK
ZONE 3: OK ZONE 4: OK
KPD KPD
OPT DIAG
STOP