21
DYN2MS-02F-0116A17
3
START UP
3.1 Mounting and Installation
The DYN2 servo drive can be mounted vertically or horizontally (vehicle mount). The servo drives should
be mounted by its rear chassis to an electrically conductive metal panel or plate. When mounting multiple
servo drives, at least 1mm clearance should be left between each unit. The small size of the DYN2 servo
drive is compatible with modular mounting. It can be placed adjacent to other devices with 1mm clear
-
ance. Also consider the size of the connectors and cables in front of the servo drive when mounting.
The control cabinet internal temperature should not exceed 40°C. If using a fan to cool the servo drives,
the air flow should parallel the direction of the heat sink fin. The servo drive internally do not have a cool
-
ing fan. Contact DMM if servo drives need to be placed adjacent without spacing.
Assem_obcover_FP01001
WEIGHT:
A3
SHEET 1 OF 1
SCALE:1:2
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Assem_obcover_FP01001
WEIGHT:
A3
SHEET 1 OF 1
SCALE:1:2
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Assem_obcover_FP01001
WEIGHT:
A3
SHEET 1 OF 1
SCALE:1:2
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
>1mm
>1mm
Airflow
Direction
(Other Devices)
(Other Devices)
>1mm
>1mm
