ULTIMATE SERIES
COAXIAL CAR AUDIO SPEAKER
WELCOME
Thank you for buying a DLS ULTIMATE speaker.
The ULTIMATE speakers are our best speaker line but a
poor installation job can destroy the final result even from
these speakers. So if you feel unsure, turn over the instal-
lation job to someone better suited to it.
INSTALLATION
Mount the speakers in the door or in the dashboard of
your car. Normally they will fit in the factory pre-made
mounting holes. If you want an improved sound,
reinforce with a baffle of MDF-board or similar. An instal-
lation high up on the door side is to be prefered. An
alternative installation is in so called kick panels down on
each side of the floor with the speakers facing up- and
inwards towards the listener.
It is important to fasten the speakers properly in order to
avoid bad sound or rattling.
For speakers with separate filters in boxes or similar it is
vital that they are attached properly to the interior of the
vehicle to avoid rattling. Don´t place them close to the
internal wiring of the car, this can cause interference.
Avoid to install filter boxes in the door sides because
they can easily be broken because of rattling or
moisture. Make sure the cables don´t get jammed
causing a short circuit to ground. This can damage the
output circuits of the head unit or amplifier.
RUNNING-IN PERIOD
Allow the speakers to play for at least 15-20 hours. After
this time the performance is correct.
CONNECTION OF SPEAKERS
Make sure you connect the cables with correct polarity
to the speakers. Observe the markings on the terminal.
Use high quality speaker cables like DLC SC 2x2,5,
SCP 2x2,5 or similar.
UX26
Technical Assistance
For technical assistance, ask the shop where the
product was sold, or the distributor in your very
country.You can always send an e-mail to
and ask for help. Information can also be found on our
WEB-site www.dls.se
We follow a policy of continuous advancement in
development. For this reason all or part of specifications
& designs may be changed without prior notice.
DLS Svenska AB
P.O.Box 13029
SE-40251 Göteborg, Sweden
Phone: +46 31 840060, fax: +46 31 844021
E-mail: [email protected]
www.dls.se
TWEETER LEVEL SELECT
Select tweeter level in four steps by moving the small jumper inside
the filter box.
+2 dB - 0 - -2 dB - -4 dB
FACTS DLS UX26 COAXIAL SPEAKER
Size
6,5" ( 16,5 cm)
Nom. power (RMS)
100 Watts RMS
Maximum power
160 Watts
Frequency range
45 Hz-25 kHz
Sensitivity
91 dB / W / m
Magnet diameter
58 mm / 2,28”, neodymium
Outer diameter
165 mm / 6,5”
Mounting depth
63 mm / 2,48”
Mounting hole
140 mm / 5,5”
Voice coil
52 mm / 2” aluminium flat wire
Tweeter
28 mm /1,1”, nanoplate tweeter
SPEAKER PHASING
To be sure to have the correct speaker polarity (phase) you can
check this by using a 1,5 Volt battery.
Connect a cable from the battery plus-pole to the speaker plus,
and a cable from the battery minus to the speaker minus.
If the speakers are correctly connected the speaker cone should
move outwards on both right and left channel.
This check must be made on the cables going from the speakers,
to the output terminals of your car stereo or amplifier.
Filter connection UX26
Bilstereo /
förstärkare
Tweeter
Nivåval
- 4
- 2
0
+2
+INPUT- + W - + T -
Tweeter
Woofer
12
12
12
12
+
+
-
-
