DLS PERFORMANCE SPEAKERS
OWNERS MANUAL
Welcome
Thank you for buying a DLS speaker.
Install the speakers yourself if you feel confident with our
instructions and if you have the proper tools. A poor installa-
tion job can destroy the final result even from these speakers,
so if you feel unsure, turn over the installation job to someone
better suited to it.
Three-way coaxial system
These speakers have a very good sound but as always it is
important to do a correct installation.
Installation
Speaker drivers:
This kind of speakers are usually mounted in the car’s par-
cel shelf. In some older car’s it may also be possible to install
them in the door. We recommend you to install the drivers in
a strong baffle of MDF-board or similar, this will improve the
sound very much. It is important to fasten the speakers pro-
perly in order to avoid bad sound or rattling.
They must be fastened securely to prevent danger to oc-
cupants in a collision or sudden braking.
Crossover:
All crossover components are integrated on the speaker.
The coil on the side of the magnet must not be removed, it is a
part of the crossover to the woofer.
Wiring:
Use high quality speaker cables. Make sure the cables don’t
get jammed causing a short circuit to ground. This can dama-
ge the output circuits of your head unit or amplifier.
Break-in period
Allow the speakers to play at normal volume for at least 15-20
hours. After this time the performance will be correct.
Technical Assistance
For technical assistance ask the shop where the product was
sold or the distributor in your country.
You can also send an e-mail to [email protected]
Information can also be found on our web-site www.dls.se
We follow a policy of continuous advancement in development.
For this reason all or part of specifications & designs may be
changed without prior notice.
Warranty service
This speaker is covered by warranty, depending on the condi-
tions in the country where it is sold. If the speaker is returned
for service, please include the original dated receipt (or a copy)
with the product.
Speaker phasing
To be sure to have the correct speaker polarity (phase) you
can check this by using a 1,5 Volt battery.
Connect a cable from the battery plus-pole to the speaker
plus, and a cable from the battery minus to the speaker
minus.
When the speakers are correctly connected the speaker
cone should move in the same direction on both right and left
channel.This check must be made on the cables going from
the speakers, to the output terminals of your car stereo or
amplifier.
DLS Svenska AB
P.O. Box 13029
SE-40251 Göteborg, Sweden
Tel: +46 31 840060
Fax: +46 31 844021
E-mail: [email protected]
www.dls.se
Connection of speakers
Make sure you connect the cables with correct polarity to the
speakers. Observe the markings on the terminals, the small
pin is minus (-) and the wide pin is the positive (+) terminal.
M569
6x9”
3-way coaxial
Technical data
:
M 569
Article number
10-22569
Bass driver
6 x 9” / 236 x 165 mm
Midrange driver
25 mm silk dome
Tweeter
20 mm mylar
Impedance
4 ohm
Nom. RMS power
100 Watt
Max / Peak- power
150 / 250 Watt
Frequency range
45 Hz - 20 kHz
Magnet size
100 mm / 3,15”
Mounting hole
221 x 155 mm (4,84”)
Mounting depth
86 mm ( 3,37”)
Parametrar Fs / Vas / Qts 64 Hz / 9,1 liter / 0,78
- terminal
+ terminal
