DKC INFO1200, Руководство пользователя

Страница: 41 / 52

39
4.3 Turn on and off the UPS
1. Press the power button (Info) or hold it for 3 seconds (Info LCD) and make sure there
are no alarms.
2. Turn on connected user devices.
3. In the event of a mains failure or a power surge, the UPS will switch to battery mode,
the red LED will light up and an alarm sound will be given. It is recommended to
disconnect non-priority devices to extend battery life. When the battery is completely
discharged, the UPS turns off, and when the mains voltage is restored, it automatically
starts again.
4. Press the power button (Info) or hold it down for 3 seconds (Info LCD) to turn the
UPS off.
ATTENTION! In the case of mains failure, the user can turn on the UPS to supply the
load (the “cold start” function).
Laser printers and scanners, as well as non-computer equipment (medical equipment,
microwave ovens, vacuum cleaners) should not be connected to the output sockets with
redundancy, because it can lead to overload due to high value of starting current.
4.4 Software installation (only for USB / RS232 models)
Please follow the instructions below to install the software on your computer and monitor
the UPS remotely.
• Insert the software CD into the CD drive
• Click on the installer file and follow the instructions on the screen.
• Connect the UPS to the computer with an USB cable and run the software.