DJPOWER
1
0
5.
5
DMX Mode & Operation
The Spark Machine V-
3
works with a DMX controller.
•
Connect the product to a suitable power outlet.
•
Turn the product on.
•
There are 4 buttons on the wireless remote transmitter which act as triggers. Each button can be assigned to a different Spark Machine
V-
3
. You may only choose 1 dipswitch on each receiver. See the below configuration options for setting the receivers to operate with
the transmitter remote.
Mode
Dipswitches
CH1
1 = On, 2-4 = Off
CH1, CH2
1, 2 = On, 3,4 = Off
CH1, CH2, CH3
1, 2, 3 = On, 4 = Off
CH1, CH2, CH3, CH4
1, 2, 3, 4 = On
…
…
•
Press the button, and the Spark Machine V-
3
will output spark momentarily for as long as you hold down the button (no more than 30
seconds). The screen display as below:
•
Release the button, Spark stops. The screen display as below:
•
Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on the
product.
5.
5
.1
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels. If you choose a
starting address that is too high, you could restrict the access to some of the product’s channels.
DJPOWER® V
-
3
DMX uses 2 DMX channels, which defines the highest
configurable address to 511 to have all channels controllable.
Set the Spark Machine V-
3
starting address in the 001 - 512 DMX range. This enables control of up
to 256 products in the 2-channel personality.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product, or
press repeatedly “MENU” button until the LCD shows “DMX
Address”.
P
ress “▲” or “▼” to set
desired DMX starting address.
