©2014 DJI. All Rights Reserved.
5
Caution
When flying, fast rotating propellers may cause serious damage and injury. Please fly safe at all times.
Assembly Cautions
(1)
Mount the GPS module with a bracket, to avoid interference with the power board on the center frame.
(2)
Ensure the IMU is mounted with the arrow pointing toward the front.
(3)
If using a receiver, attach it under the bottom board of the center frame with the end of the antenna
facing downwards away from obstructions to avoid loss of control due to signal loss.
(4)
Ensure frame arms are mounted correctly.
a)
Motor mounts with CCW marks should be mounted to the corresponding center frame positions
with the following marks: M1, M3, M5, and M7.
b)
Motor mounts with CW marks should be mounted to the corresponding center frame positions with
the following marks: M2, M4, M6, and M8.
(5)
Do not remove any glued-in screws.
(6)
Tighten screws appropriately. Screws marked with blue glue can be used without thread locker once. On
other occasions, apply appropriate thread locker.
(7)
S1000 should be raised above the ground when testing landing gear or recalibrating servo travel.
(8)
Notice that matching the indicators is very important. Please pay attention to them.
Flight Cautions
(1)
ESCs are not water-proof, do not fly in rain or snow.
(2)
Ensure all soft dampers and vibration absorbers are in good condition before every flight. If not, replace
immediately. Otherwise, the flight performance of your aircraft will be adversely affected.
(3)
Ensure all parts are in good condition before each flight. Do not fly with worn or broken parts.
(4)
Ensure propellers and motors are installed correctly and propellers are unfolded before flying.
(5)
Ensure ESC signal connectors and power cable connectors are tight and reliable before every flight.
(6)
When flying, stay away a safe distance from people, buildings, high-voltage lines, tall trees, water and
other hazards.
(7)
Use only 6S LiPo batteries for the power supply.
(8)
Ensure all output signals from M1 to M8 are in proper working order when using the DJI A2 flight control
system to avoid damage or injury.
(9)
Do not overload the system.
(10)
Do not get close to or touch motors or propellers when they are spinning as this can cause serious injury.
(11)
Disconnect battery and remove camera during breaks and transportation to avoid damage or injury.
(12)
We strongly recommend using as many DJI parts as possible.
Others
(1)
If you have any problem you cannot resolve, contact your dealer or DJI customer service.
