©2012 DJI Innovations. All Rights Reserved.
4
Contents
OSD Controller ×1
Connect the OSD controller to your DJI autopilot
system via
CAN-Bus. It communicates with the main
controller, receives data from the main controller,
superimposes the data with the video image, and
then transmits the whole information via a
transmitter.
CAN-Bus Cable
×1
Connect the OSD to your autopilot system through a
CAN-Bus cable.
D
JI
D
JI
Video Input Cable ×1
Connect the OSD with video input source (i.e.
camera or DJI Z15) for video input and power
supply.
Only when you use the DJI Z15, you can use the
bi-port cable directly for the connection. Otherwise,
you can use the one-port cable for your own
connection in accordance with the wiring diagram.
Video Output Cable ×1
Only when you use the wireless video transmitter
module specified by DJI, you can use the bi-port
cable to connect the OSD with the video transmitter
module. Otherwise, you can use the one-port cable
for your own connection in accordance with the
wiring diagram.
2-PIN to 3-PIN Cable ×1
Connect the OSD with the R/C receiver through this
cable. When there are two video signal inputs, it is
used for the selection of video signal sources.
