Dixon ZTR 700 Series, Руководство оператора

Страница: 9 / 21

D. Slow engine speed with throttle to
slowest position.
E. Turn ignition key to "OFF" (left)
position.
F. Remove the key and wait for all
movement and all sound to cease
before dismounting.
11. BRAKING: To brake mower, gently
move the Steering Control Levers in the
direction opposite to travel. If the parking
brake is engaged with the Steering Control
Levers in the "IN" position the engine will
stop.
12. CUTTING HEIGHT ADJUSTMENT: With
the Cut Height Adjustment Lever latched
into the top cut height latch. Insert Cut
Height Stop Pin to desired cutting height.
Pull Cut Height Adjustment Lever
rearward and then to the right to clear top
cut height latch. Lower Cut Height
Adjustment Lever until it rests on Cut
Height Stop Pin.
13. ENGAGE MOWER BLADE CLUTCH:
Set the Blade Clutch Switch to the "ON"
position. The engine will not start if the
blade clutch is engaged. If the operator is
not in the seat, the engine will stop if the
clutch is engaged.
15. TO FREE WHEEL MACHINE: UNLOCK
TRANSMISSION: The transmission release levers
are located on each side of the mower behind the
rear drive axles and below the engine mounting
plate. Lift the levers slightly, push them forward
and then down to release the transmissions for
free wheeling. To engage the transmissions lift
the levers slightly, pull them to the rear and then
down. NOTE: The tractor should never be pulled
at more than 2 miles per hour or for any
appreciable distance.
14. TO STOP:
A. Move Steering Control Levers to neutral
position and then to the "OUT" position.
B. Disengage the mower blade clutch
by moving the clutch to the "OFF"
position.
C. Set the parking brake.'"
P-11408 (2/99) 5