Dixon ZTR 503, Руководство оператора

Страница: 10 / 33

Page 7
SEAT ASSEMBLY INSTRUCTIONS
1. Assemble seat as shown in picture. Do not fully tighten the bolts -,-'hich secure
left and right arm rest brackets to seat bottom until seat back and tool box are
installed. This will aid alignment of all parts.
2. Place seat assembly on rear body cover, connect seat safety switch.
3. Insert the (2) rear studs of the seat slide into the rear holes of the body cover.
Firmly hold seat assembly against body cover with one hand while rear body is
raised to fully open position. Continue to hold seat against body to prevent damage
to seat safety switch wiring.
4. Install (1) flat washer and (1) nylok nut on (1) of the rear studs extending
through body cover and seat frame, tighten a few threads to hold seat assembly in
place.
5. Position seat on front holes and install all remaining washers and nylok nuts.
Tighten all nuts fully.
SEAT ASSEMBLY INSTRUCTIONS SEAT
NOTE: HARDWARE FOR CONTROL LEVER ASSEMBLY