Dixon ZTR 304, Технический данные брошюры

Страница: 2 / 7

Page 2
"IMPORTANT" - PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS
1. A f t e r reassembly, while seated on mower attempt to s t a r t engine w i t h mower
deck engaged. Engine should not start. If engine does s t a r t , r e t u r n the mower
to an Authorized Dixon Dealer f o r adjustment or repair.
2. Disengage mower deck and s t a r t engine. With t h e o p e r a t o r in t h e normal
seated position, engage mower deck and remove weight from seat. The engine-
should stop. If the engine does not s t o p when operator rises from seat, return t h e
mower to an Authorized Dixon Dealer f o r adjustment or repair.
3. Engage, then disengage, mower blade in each c u t t i n g height. Insure that
blade disengages and comes to a stop w i t h i n (5) seconds in each height position.
If blade does not disengage properly contact your A u t h o ri z e d Dixon Dealer.
PARKING BRAKE ADJUSTMENT
1. Raise upper body to the open position.
2. Tighten nut on brake rod (P/N 2533) located in front of the transaxle
on each side, just enough to prevent brake from slipping when engaged.
CAUTIQN: Over tightening may cause premature wear on the brake bank (P/N
5085).
REMOVING THE MOWER BLADE
Secure blade (P/N 2483) from turning. Remove blade bolt from center (P/N
3268), lock washer (P/N 3065) and blade washer (P/N 6113), then blade (P/M
2483). To reinstall, reverse above procedure. . WARNING; Sharp edges on
blade can cause injury!
Caution should be exercised when service is required on blade.
(P/N 8112)
DIXON INDUSTRIES, INC.
Box 1569 Coffeyville. Kansas 67337-0945 (316) 251-2000 Airport Industrial Park
TELEX: 417109