1
Setup
Uncrate machine.
ROPS Assembly
(Roll Over Protection System)
ROPS Assembly Components
1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2’’ Latch Pins w/lanyard
6 - 1/2C x 3 1/4’’ Cap screws
6 - 1/2C Centerlock Nuts
2 - Knobs
(all hardware Grade 5).
1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.
a. Locate the LEFT and RIGHT side posts.
b. Slide the left side post into the left side
receiver on the frame, do the same on
the right side.
c. Using 1/2C x 3 1/4 cap screws, two per
post, align the holes in the side post with
the frame receiver.
d. Install the 1/2C centerlock nuts finger tight
to the side post bolts.
3. Install roll bar top loop.
a. Align the holes of the top loop with the left
and right side posts.
b. Slide the latch pins through the front hole
on the left and right side to connect the
top loop to the side posts. Secure with
the hairpin.
c. Using 1/2C x 3 1/4 cap screws through
the rear hole on the left and right side.
d. Install the 1/2C centerlock nuts finger
tight.
4. Torque all 1/2’’ hardware to 80 ft./lbs. (110 N•m).
5. Install and tighten knobs against the side
post.
Set-Up Instructions
for CE RAM Models
PART NO. 539 130502 REV. IR (01/25/07)
1. Latch Pin
2. Top Loop
3. Knob
4 1/2C x 3 1/4 Cap Screws
5. 1/2C Centerlock Nuts
6. Right Side Post
7. Left Side Post
1
2
3
4
5
6
7
5
4
