Installation Instruction
ALG Series LED Area Light Version: 3.1
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/ abrasions,
and other hazards please read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
Installation and service of luminaires should be performed by a qualified licensed electrician.
Maintenance of the luminaires should be performed by person(s) familiar with the luminaires’ construction and
operation and any hazards involved. Regular fixture maintenance programs are recommended.
It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on
ambient dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a solution
of warm water and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry. Should optical
assembly become dirty on the inside, wipe refractor/lens and clean in above manner, replacing damaged gaskets as
necessary.
DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have
been damaged during transit. Thoroughly inspect the fixture for any freight damage; freight damage should be
reported to the delivery carrier.
WARNING: RISK OF ELECTRIC SHOCK
RISK OF ELECTRIC SHOCK. Make sure power supply is OFF before installing or maintaining fixture. No user
serviceable parts inside.
Verify that supply voltage is correct by comparing it with the luminaire label information.
The fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety.
All wiring connections should be capped with UL approved recognized wire connectors.
WARNING: RISK OF BURN
Never perform maintenance or cleaning while fixture is energized. Disconnect power and allow fixture to cool before
maintaining.
Do not exceed maximum wattage marked on luminaire label.
Follow all manufacturer’s warnings, recommendations and restrictions for: driver type, burning position, mounting
locations/methods, replacement and recycling.
CAUTION: RISK OF INJURY
Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or performing
maintenance.
Avoid direct eye exposure to the light source while it is on.
CAUTION: RISK OF FIRE
Keep combustible and other materials that can burn, away from lamp/lens.
Do not operate in close proximity to persons, combustible materials or substances affected by heat or drying.
CAUTION: RISK OF PRODUCT DAMAGE
Never connect components under load.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
Controls for dimming, auto-sensing, or remote control of a luminaire that are not factory-wired to the luminaire must
be checked for compatibility with the luminaire prior to installation. Never connect an LED product directly to a
dimmer pack that has not been pre-approved. LED fixtures must be powered directly off a switched circuit.
