CarScope VISO Getting started manual
DITEX
Version 2.0/2016-08-30 - 3 - www.autoditex.com
3. Charging the battery
A suitable charger is included with the device for charging the battery from any standard outlet.
You can use any 5V DC charging adapter with output current no less than 1.5A. Adapter charging
connector should be DC power plug 2.1mm x 5.5mm, center pin positive (+).
Important note:
Don’t use CarScope VISO device for measurements when battery is being charged!!! Don’t
connect measurement probes to both channel inputs when battery is charging!!!
Note: Charging may take up to 4 hours when the battery is completely discharged.
Note: Do not wait until your battery is completely depleted before charging your device. Repeating
this process of a complete discharge and recharge can over time reduce the storage capacity of
any battery!
4. Multifunctional button description
Multifunctional button has the following functions explained below:
1.
Press and hold down the “multifunctional button” for about 4 seconds to switch on the device.
2.
Press and hold down the “multifunctional button” for approximately 10 seconds to make an
emergency power off.
3. Press the “multifunction button” briefly to get back to the previous screen.
4. Double press the “multifunctional button” to go directly to the home screen.
5. Switching the device ON and OFF
To turn the device on:
Press and hold the “multifunctional button” for approximately 4 seconds until the device switches
on and then release the button.
Important note:
You’ll have to wait for at least 10 seconds after installing the battery before
switching on the CarScope VISO device for the first time!
To turn the device off:
From home screen, tap “Turn off button”
to power off CarScope VISO.
Emergency power off:
Press and hold down the “multifunctional button” for approximately 10 seconds to make an
emergency power off.
6. LEDs description
CarScope VISO device has two LEDs which have the following functions:
“OK” LED (green)
– initial self-test status:
-when devi
ce is turned successfully on, “OK” LED lights continuously;
-
when device is in sleep mode, “OK” LED lights briefly in 2 seconds interval;
-
when device is turned off, “OK” LED is not active.
“Charging” LED (red)
lights when the battery is being charged.
