CarScope VISO
Getting started manual
DITEX
Version 2.0/2016-08-30
- 10 -
www.autoditex.com
BMPFILES
folder contains stored BMP files.
FWUPDATE
folder is intended for firmware update files.
HELP
folder contains files in subfolders with help information.
SYSTEM
folder contains CarScope VISO system files and folders.
VWFFILES
folder
contains user’s custom stored waveform (VWF) files.
Important:
Do not change the folder names described above because they are used from CarScope VISO as
working folders.
Do not delete, rename or move files and folders from the HELP folder because
this will cause improper work of the help system. All files are saved in an internal micro SD
memory card.
1
3. CarScope VISO firmware’s update procedure
1. Connect powered CarScope VISO to the computer with a USB cable.
2. Choose "Data Management" from the home screen. CarScope VISO display shows "Connect to
PC". Wait about 10-20 seconds (or more) until the computer recognizes CarScope VISO as a
removable disk.
3. Copy the firmware file (for example CSViso88.SUF) with new firmware from the computer to
X:\CSVISO\FWUPDATE\
CSViso88.SUF on CarScope VISO. “X” is the drive letter of the
removable device.
4. Go back to the home screen with the "Back" button.
5. Choose “Settings” from the home screen and then choose "Firmware Update".
6. A message "Checking for firmware updates" and a progress bar are showed.
7. After a successful search for firmware update files, the following message appears: "Select
firmware update file".
8. Choose the desired firmware update file (for example CSViso88.SUF) and an attention
message appears. At this moment CarScope VISO waits for firmware update confirmation.
9. Next series of messages about the stages and the progress of the firmware update procedure
will be shown.
10. After a successful firmware update, the following message appears:
"Firmware has been successfully updated to version: CarScope Viso V0.88"
Note: All details related to the firmware update process are recorded in a LOG file and are
available to the user for analysis of a possible problems encountered by the manufacturer. This
LOG file can be found in X:\CSVISO\FWUPDATE\
FWUPDATE.LOG. “X” is the driver letter of the
removable device.
