Dishlex DSF6206W, Руководство пользователя

Страница: 12 / 16

Cleaning the spray arms
Do not remove the spray arms. If the holes in the spray
arms are clogged, remove remaining parts of soil with a
thin pointed object.
External cleaning
• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.
Internal cleaning
• Carefully clean the appliance, including the rubber
gasket of the door, with a soft moist cloth.
• If you regularly use short duration program, these
can leave deposits of grease and limescale inside
the appliance. To prevent this, we recommend to
run long duration program at least 2 times per
month.
Troubleshooting
If the appliance does not start or it stops during
operation. Before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
With some problems, the display shows an alarm
code.
Problem and alarm code Possible solution
You cannot activate the appliance. • Make sure that the mains plug is connected to the mains socket.
• Make sure that there is no a damage fuse in the fuse box.
The program does not start. • Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end of the count-
down.
• The appliance has started the procedure to recharge the resin inside the
water softener. The duration of the procedure is approximately 5 minutes.
The appliance does not fill with wa-
ter.
The display shows .
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the
water.
The display shows .
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows .
• Close the water tap and contact an Authorised Service Centre.
Once you have checked the appliance, deactivate and
activate the appliance. If the problem occurs again,
contact an Authorised Service Centre.
For alarm codes not described in the table, contact an
Authorised Service Centre.
12