Fig. 3
3ft. Audio cable
Fig. 4
Module
4.
Install microphone to headliner with included visor clip
5.
Route microphone cable (10 ft. long) down pillar, under dashboard and
into radio cavity
6.
Connect microphone jack to
module “MIC” input. (See
Fig. 5
)
Wind noise (Convertibles) will negatively affect phone audio. Users are
advised to install microphone away from wind/ventilation ducts etc. or
opt for push button microphone seen in
Fig. 7
Visor microphone
Fig. 5
7.
Connect/splice/tap module red wire (See
Fig. 6
) to a 12V accessory
(switched) supply in vehicle. 12V
accessory or switched supply
may
be available at cigar lighter Orange/Brown wire, radio 14-pin plug pin 11
(Light Green/Orange or White/yellow) etc.
Warning:
Do not connect/tap red wire to 12V battery (always on)
supply.
Fig. 6
Optional charging kit
Optional USB charger can be added to the A2DIY-JAG97 Kit. Should you decide to
add it, we suggest one of 3 connecting options:
A
.
Flush to dash/panel requires drilling a ¾” hole
B
.
Flush with Support bracket
(Mount USB terminal wherever your installation
demands without drilling)
C
.
USB port-
(default)
