PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•
Careless installation and operation can result in equipment damage
.
Requirements
OEM Radio with CD button on faceplate and 8-pin port at the rear
Introduction
Just because you drive an order car does not mean you have to settle for old
technology. Any pre-1998 Jaguar with CD changer controlling radio (TAPE/CD
button) is compatible with this module and able to make/received phone calls,
stream apps (Music, GPS etc.) and also connect and play an AUX device (e.g. MP3
player, iPod, Sat radio etc.) In addition, an optional USB charging por enables
charging those current hungry devices while on the road. Update older Jaguars
to support Bluetooth features only available on newer cars.
Warning:
This module installs behind the radio cavity and requires radio
removal.
CD changer (if present) must be disconnected
—
See our
to retain CD changer playback.
Installation
Radio removal required to access CD connector on radio
For help removing radio, click link below:
https://www.youtube.com/watch?v=vpAIdr6V3iE
1.
Disconnect CD changer cable
(if present) from “CD”
connector on
radio
2.
Connect module 8-pin plug (See
Fig. 1
) to radio 8-pin CD connector
(See
Fig. 2
)
Fig. 1
Fig. 2
radio
3.
Connect supplied (3ft.) audio cable (See
Fig. 3
) to Module
“AUX” input
jack, (See
Fig. 4
), route other end to dash area or location where
device resides (within 3ft).
