8.
Connect or Tap installation harness red wire (See
Fig. 2
) to ACC
(Accessory) power supply in vehicle.
We suggest one of the following options:
- In 1997-03, locate yellow wire on 3-pin plug under passenger toe
board near BCM (may be covered with black duct tape). Yellow wire is
accessory supply. (See
Fig. 8
)
Fig. 8
Note: 3-pin plug omitted in 2004
- Alternates include interior fuse box
#11
or
#22
slots
- Other possible fuse slots highlighted in red. (See
Fig. 9
). Please turn on all
accessories, including wipers, rear defroster, A/C and test for engine noise
prior to final install.
Fig. 9
toe board fuse box
USB Charging Port Installation
An updated
“SMART”
USB charging port has been added to module which charges
based on device current demands and used for charging only.
(Not for thumb
drives etc.)
A
.
Flush to dash/panel requires drilling a ¾” hole in the dash
B
.
Flush with Support bracket
(use this option to mount USB terminal
wherever your installation demands without drilling)
A.
Flush to Dash or Panel
(drilling required)
1.
Drill a ¾” hole in the dash or panel using a step drill bit or equivalent
(See
Fig. 10
)
Fig. 10
Step drill bit