Pull
A
B
Pressure Washer
Introduction & Quick Connect System ......................................................................................................... 2
Important Safety Instructions ...................................................................................................................... 3
Specific Safety Rules and Symbols .......................................................................................................... 4-5
Electrical ................................................................................................................................................ 6
Features ................................................................................................................................................ 7
Assembly ............................................................................................................................................ 7-8
Operation ...........................................................................................................................................9-10
Maintenance ......................................................................................................................................... 11
Troubleshooting .................................................................................................................................... 12
Reference Figures .............................................................................................................................13-15
Wet/Dry Vac
Important Safety Instructions .................................................................................................................... 16
Features .............................................................................................................................................. 17
Operation .........................................................................................................................................17-18
Maintenance ......................................................................................................................................... 19
Troubleshooting .................................................................................................................................... 20
2
19
MAINTENANCE
TABLE OF CONTENTS
Filter
Your filter should be cleaned often to maintain peak vac performance.
NOTE: The filter is made of high quality material designed to stop small particles such as sawdust. Handle the filter
carefully when removing to clean or installing a new filter. Do not tear the filter during removal or installation if
your intent is to reuse the filter.
Easy to Replace Filter
1. Extend the retainer band around the plastic posts on the lid.
2. Remove filter bag off the filter cage.
3. Place the replacement filter on the filter cage until open end touches bottom of lid.
4. Release the retainer band from the plastic post on the lid, holding the filter bag secure to the lid.
5. Make sure the retainer band is positioned on the filter bag covering the black printed line.
IMPORTANT:
To avoid damage to the fan and motor, always reinstall the filter before using the vac for dry mate-
rial pick-up.
Take the dirty filter to a disposal container and gently brush away small dirt particles that may be adhering to the
filter material.
IMPORTANT:
After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it.
Even a small hole can allow a lot of dust to come out of your vac. Replace it immediately.
Installation
Before installing the filter on the vac, clean the area of the lid so that the retainer band will seal the bag against the
lid and stop small particles from bypassing the filter bag.
If the filter is clean and not damaged, replace it on the filter cage. If it cannot be reused, place a new filter over the
filter cage.
Replace the retainer band around the filter. Make sure the retainer band is positioned on the filter, and the filter
completely covers the filter cage. Also, make sure the edges of the filter are completely secured under the re-
tainer band.
WARNING:
Do not remove the filter cage and float. The float prevents liquid from entering the impeller and damaging
the motor. The cage prevents fingers from touching the moving impeller.
Retainer
Band
Lid
Motor Housing
(upside-down)
Plastic
Post
Filter
Bag
This Pressure Washer’s metal hose coupler has been replaced by an easy to use quick connect. The quick connect system consists of
a male end nozzle (A) and a female end coupler (B), and will come assembled and attached to the Pressure Washer.
With the hose faucet turned off, disconnect the female coupler from the nozzle by pulling back on the collar in the direction away from
the pressure washer. Secure the female coupler to the hose end by tightening the threads of the two pieces.
Attach the garden hose with assembled female hose coupler to the unit by pulling the collar back & moving the female coupler over top
the male end nozzle.
When use of the pressure washer is complete, unthread the garden hose from the female coupler and leave the entire quick connect
system attached onto the unit for easy-to-access onboard storage.
Note: Any other reference to the metal hose coupler later in the manual should be substituted with the included quick connect system
that is explained above.
This product has many features for making its use more pleasant and enjoyable. Safety, performance, and dependability have been given
top priority in the design of this product making it easy to maintain and operate.
INTRODUCTION
QUICK CONNECT SYSTEM
