page 19 of 32
MI6 Manual - Version 1.1
CHAPTER 4: Operation
Sync
The MADI input is used as sync source for the device.
SYNC
LED (green) - indicates the lock / sync state
of the device
(OFF) - no input signal detected
(ON) - valid input signal detected
The channel mode (56ch <> 64ch) is detected automatically.
All MADI outputs carry the signal of the active MADI input.
The device will switch to 2 FS operation automatically when a 96k Frame signal
has been detected.
Input Selection
One of the three MADI inputs is used as general input source.
Selection priority of locked inputs: BNC > SC > SFP
The active MADI input signal is divided into four banks four banks with 16 channels
each. The bank is selected by pressing the push button (loop selection).
LED ‘INPUT’
<1..> / <17..> / <33..> / <49..>
4 LEDs (green) - indicate the bank
selection of the MADI signal.
channel 01 .. 16 selected
channel 17 .. 32 selected
channel 33 .. 48 selected
channel 49 .. 64 selected
‘INPUT’
<1..> / <17..> / <33..> / <49..>
Push button - bank selection of the
MADI signal.
Press to cycle the bank selection.
Press and hold > 2 s to override key lock.
