DirectOut Technologies D.O.TEC ANDIAMO.AES, Руководство по оборудованию, Страница: 33 / 56

DirectOut Technologies
®
page 33 of 56 D.O.TEC
®
ANDIAMO.AES (SRC) Hardware Guide - Version 1.0
CHAPTER 4: Operation
© 2013 DirectOut GmbH
Matrix Mode
To setup an individual routing on a per channel basis the remote
control software (ANDIAMO Remote) is required. The settings of
the routing matrix are stored inside the device. So it is possible to
toggle between both routing methods without using the remote con-
trol.
See „CHAPTER 5: Menu Navigation“ on page 38 or ‘Software
Guide ANDIAMO Remote’
.
signal Routing at 2 fs
At 2 FS the number of transmitted channels in the MADI stream is
reduced, only 32 channels are available.
This also involves some specifi cs:
• both LEDs (01..32 and 33..64) will glow when MADI is select-
ed as signal source for ‘AES ▲ ’ or ‘AES ▼ ’ at 2 FS operation.
•
setting ‘01..32’ means the lower half of the MADI signal; i.e.
channels 01-16.
• setting ‘33-64’ means the upper half of the MADI signal; i.e.
channels 17-32.
Some routing examples are illustrated here: „Appendix B: Confi gu-
ration Examples“ on page 50 .
To mute a destination, set the source to nothing (no LED glowing in
that source column).
If all 16 LEDs of the routing matrix are <ON> the ‘Matrix Mode’ is
enabled.