DirectOut Technologies D.O.TEC ANDIAMO.AES, Руководство по оборудованию, Страница: 31 / 56

DirectOut Technologies
®
page 31 of 56 D.O.TEC
®
ANDIAMO.AES (SRC) Hardware Guide - Version 1.0
CHAPTER 4: Operation
© 2013 DirectOut GmbH
If the clock source is set to AES the selection of the AES port as
clock source uses the following pattern in ascending order:
lowest input port receiving a valid AES signal and SRC switched off
Automatic AES port selection - a change of the AES input signal
condition or changing the activation status of the SRCs may result
in a different clock source.
AES SRC Version
level Meters - digital i/o [AEs sRC]
AES ports 1-16 (17-32) have an individual display with four (three)
LEDs each. A SYNC LED indicates the sync state for each port
individually. The clock priority follows an ascending order (port 1,
port 2, ...).
sYnC (Port 1-32) lEd (green): indicates
sync status of the AEs input
LED ON = AES signal is in sync
LED blinking = AES input signal is
locked but not in sync or scaling
factor does not match.
LED OFF = no signal detected
sRC (Port 1-16) lEd (blue): indicates activation status of
sample rate converter at the AEs input
LED ON = SRC is active
LED OFF = SRC is inactive
sig (input) lEd (green): indicates
signal level of channel input
LED ON = digital input signal
equals to more than -80 dB
FS
The light intensity of the LEDs
depends on the audio level.
sig (output) lEd (green): indicates
signal level of channel output
LED ON = digital output signal
equals to more than -80 dB
FS
The light intensity of the LEDs
depends on the audio level.