page 24 of 36
ANNA-LISA Manual - Version 1.1
CHAPTER 4: Operation
Sample Rate
If an input signal is present on the selected input (‘INPUT SYNC’ is blinking/ON)
and its sample rate is within a 5 Hz range around 44.1/48 kHz, the corresponding
led is lit green for 1 FS sample rates, and yellow for any higher sample rate factor.
Pressing ‘SET’ lets you confi gure the clock reference that is used for both the sync
check of the incoming signal and generating the outgoing signal. The ‘SAMPLE
RATE’ led will now blink, and every push of ‘SET’ cycles you through the settings.
Code
Meaning
LED Code
external clock of the selected input,
display depends on input signal
--
internal clock, 44.1 kHz, 1 FS
44.1 ON green
48 OFF
INT ON yellow
internal clock, 48 kHz, 1 FS
44.1 OFF
48 ON green
INT ON yellow
internal clock, 44.1 kHz, > 1 FS
44.1 ON yellow
48 OFF
INT ON yellow
internal clock, 48 kHz, > 1 FS
44.1 OFF
48 ON yellow
INT ON yellow
Pressing ‘SELECT’ exits the sample rate submenu.
Parameter: SAMPLE RATE
Values: 44.1 / 48 / INT