DirectOut Technologies ANDIAMO 2.AD, Руководство по оборудованию

Страница: 26 / 44

page 26 of 44 D.O.TEC
®
ANDIAMO 2.AD Hardware Guide - Version 1.0
DirectOut Technologies
®
CHAPTER 4: Operation
© 2013 DirectOut GmbH
bank selection / signal Routing
The bank selection defi nes the block of channels in the MADI stream
that is fed by the analog inputs. This selection also affects the sig-
nal source for the line outputs that are fed by the MADI input signal
(‘Standard Bank Routing’).
The remaining MADI data passes the device unchanged.
The bank selection is indicated by two LEDs. At 2 FS operation a
maximum of 32 channels are transmitted in a MADI signal; so there
is no selection possible then.
The LEDs for the bank selection are also used to indicate the activa-
tion status of the ‘Matrix Mode’ (
see „Matrix Mode“ on page 27
)
and delay compensation.
33..64 lEd (green): indicates the selection
of the converted audio channels.
LED ON = audio channels 33 to 64
(29 to 56 of a 56 ch signal) are converted
LED heartbeat = delay compensation active,
audio channels 33 to 64 are converted
1..32 lEd (green): indicates the selection
of the converted audio channels.
LED ON = audio channels 1 to 32
(1 to 28 of a 56 ch signal) are converted.
LED heartbeat = delay compensation active,
audio channels 1 to 32 are converted
See „Delay Compensation“ on page 30 for more information
about daisy-chaining of ANDIAMOs.
If both Bank LEDs are <ON> ‘Matrix Mode’ is enabled.
If both Bank LEDs <heartbeat> ‘Matrix Mode’ is enabled and delay
compensation is active.