P.18
User Guide
Swap start:
If
this feature is enabled; Rapidly press
AUX
twice. The
remote’s LED will start flashing. While the LED is flashing, press
to remote start the car. The
AUX 2
output can be activated by
pressing the
button.
Engine Run Time
On a gas engine, the Remote Car Starter can be programmed to run the engine
for 3, 15, or 25 minutes (15 minutes by default). On a diesel engine, the Remote
Car Starter can be programmed to run the engine for 8, 20, or 30 minutes
(20 minutes by default).
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down
after the user leaves the vehicle: the unit will take over the vehicle and keep it
running for 60 seconds (or until it is shut down by remote control), then shut
down the engine.
If your vehicle has an
automatic transmission
, proceed as follows to set the
system to Turbo Mode:
1. With the engine running, make sure to release the brake pedal and
press the
,
or
button on the transmitter until the parking lights
come
ON
.
Note:
SmartStart™ can be setup to use the SmartStart™ icon to activate
Turbo mode.
2. Remove the ignition key from the ignition switch. The engine will
continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the
button; this will lock the doors, arm the OEM-style
alarm (if configured|) and confirm that the vehicle is in Turbo Mode.
5. The engine will shut down after 60 seconds.
If your vehicle has a
manual transmission,
follow all steps of the
Ready Mode
routine
(page 9)
to activate Turbo Mode. At the last step,
Press
to lock the doors and have the engine shut down after
60 seconds;
