Directed Directechs TL10, Руководство по установке, Страница: 5 / 66

5
DS4+ TL10
© 2017-05-29 Directed. All rights reserved.
Introduction
The TL10 firmware for DS4+ is compatible with specific TOYOTA and LEXUS vehicles. It is a complete solution
for remote start, security (when security features are enabled), bypass, and features built in Bluetooth 4.0
allowing you to configure and control your system. This guide provides information on the installation of the
module as an analog unit, however a digital solution could be available for your vehicle. Please refer to the
DirectLink application or www.directechs.com for more information about which configuration is best for your
application.
Warning!
This module is designed to be configured using the DirectLink application for mobile devices, however it can also
be configured using the web tool located at www.directechs.com. To download the DirectLink mobile application, please visit the
Google Play or Apple store.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THTON3,
THTON4, THTON5
Keys required for
programming
1
Keys required for
operation
0
Š
This guide is compatible with TL10 v2.12+.
Š
The optional Plug & Play
THTON3
,
THTON4
or
THTON5
T-Harnesses are sold separately. Refer to the "Vehicle wiring
reference chart" for vehicle and t-harness compatibility.
Š
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
Š
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Š
It is important to check that the fuses are positioned correctly in the module. Refer to the "Fuse selection" section following
each installation type for more information.
Š
Refer to the "Vehicle wiring reference chart" following each installation type.
Š
It is important to make sure you
DO NOT
connect the keysense wire in the installation for each of these vehicles or you will
encounter issues when attempting to start the vehicle.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin.
[2]
The siren is
ONLY
required when enabling the security features during Directed DS4 module flashing.
[3]
The Green wire is only required for starter disable and antigrind connections.
[4]
Autolight Interrupt connection required only if the vehicle is equipped with automatic headlights.
[5]
SIL Interrupt connection required
ONLY
if the vehicle is equipped with TPMS (Tire Pressure Monitoring System).
[6]
Trunk release connection required when not available through Data.
Additional parts required (maximum required):
Diode 6A
0 x 1A Diodes
86 85
30
87a
87
0 x Relay
Resistor 100
Ω
0 x Resistor
Fuse 7.5A
0 x Fuse