14
Directed Digital Solutions NISS07
© 2017-07-12 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 15 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note
: To skip the transponder programming and use convenience features only,
press
the
programming button 5 times. Wait until the LED turns on solid orange then proceed with
step 4.
Must be connected LAST
&
Solid
4
Turn
the key to the ON position.
The LED turns ON green for 3 seconds then shuts OFF.
Note
: If the bypass was skipped, the LED flashes orange, then turns ON solid orange for 3
seconds before turning OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
Solid x 3 secs
Off
&
5
Turn
vehicle ignition OFF once the module is successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
7
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 18.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.