17
Directed Digital Solutions HYUNDAI8
© 2016-12-02 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 18 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Must be connected LAST
&
Solid
4
Make sure the key is inside the vehicle.
Note:
To skip the transponder programming and use convenience features only press the
programming button 5 times. The LED will turn orange then proceed to step 2.
Key Inside
the vehicle
5
Important:
Do NOT press the brake pedal.
Press
the Push-to-start (PTS) button twice to turn the ignition ON.
&
6
The orange LED flashes then the green LED turns ON for 3 seconds and shutts off.
Note:
When skipping transponder programming, the orange LED flashes then the orange
LED turns ON for 3 seconds and shuts off.
Flashes
Orange
&
Solid ×3
&
Off
7
Press
the Push-to-Start (PTS) button once more to turn the ignition OFF.
8
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
9
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 21.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
