5
933.NISS3HT 3.15.195.3 2010 Nissan Murano (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THNIN3
Keys required for
programming
1
Keys required for
operation
0
The optional Plug & Play
THNIN3
T-Harness is sold separately.
Important!
All T-Harness wires
NOT
listed in the diagram are
NOT
required for the installation. Loose wires such as Siren
Output and Hood Input may need to be pulled from the tapped section of the T-Harness. Refer to the “Wiring diagram with
T-Harness” for more information on connections and installation instructions.
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each
wiring diagram.
Refer to the "Vehicle connections" following the installation diagram.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin.
[2]
The siren is
ONLY
required when enabling the security features during module flashing.
[3]
For Security Only Installations, refer to 'Locating components in the vehicle' for the optional starter disable connection.'
