11
933.MIT3 2.11.195.3 2012 Mitsubishi Lancer Evolution
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
For
Security-Only
and
Convenience-Only
programming, see next sections.
1
Ensure vehicle is in a safe location and cannot move forward during programming. For
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
2
DS3+: Connect the 12-pin main power harness to the DS3+ module FIRST.
Wait until the LED turns ON solid red before proceeding to the next step.
DS4+: Connect the 12-pin main power harness to the DS4+ module FIRST.
The LED will turn ON solid blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns ON solid red before proceeding to the next step.
3
Connect the remaining harnesses to the module.
4
Turn the ignition ON or turn the knob to the RUN position.
5
The LED will flash green and turn ON green solid for 3 seconds when programming is
completed.
6
Turn the vehicle ignition OFF once the module is successfully programmed.
7
Pair remotes (if applicable).
For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or
on www.directechs.com.*
8
DATA/Hardwired Tach Learning: When using Data Tach, it is recommended to follow the
Tach Learning procedure. However, when using a Hardwired Tach, the procedure is
mandatory.
For more information, refer to the Tach Learning procedure section.
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.