17
403.CHRYSLER6 2.14 2014 Dodge/Ram 3500
©2022 VOXX•DEI LLC. All rights reserved.
Feature and option list
It is recommended to configure all the features and options listed below using the configuration tool found on the module flashing page at
www.directechs.com. The web offers more options; however, manual configuration of the features is possible using the information on this
page.
* Default option
Feat
.
Operation
Flashes / Option
Description
1
RFTD Output Type
1. No RF Output*
Module is connected to a remote starter using a standard installation.
2. RFTD Output
Module is connected to an XL202 using an RSR or RXT installation (when available).
3. SmartStart
Module is connected to SmartStart using an RSR or RXT installation (when available).
2
Unlock Driver Priority
1. Driver priority*
Unlocks only the driver door when the button is first pressed, and unlocks all doors when it is pressed a second
time within 5 seconds.
2. All
Unlocks all doors when the button is first pressed.
3
Heated Seats
1. Disabled*
No operation.
2. Enabled
When the feature is enabled, it will activate the Heated Seats and heated steering wheel.
4
Defroster
1. Disabled*
No operation.
2. Enabled
When the feature is enabled, it will activate the rear defroster and heated mirrors.
5
Heated
Seats/Defroster
Temperature Control
1. 32 °F (0 °C)*
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 32 °F (0 °C).
2. 23 °F (-5 °C)
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 23 °F (-5 °C).
3. 41 °F (5 °C)
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start when
temperature is below 41 °F (5 °C).
4. Always ON
When Heated Seats or Defroster feature is enabled, it will activate the feature at any temperature.
6
Heated Seats
Temperature Level
1. High*
When Heated Seats are activated, they will be set to HIGH.
2. Low
When Heated Seats are activated, they will be set to LOW.
7
Smart OEM Alarm
Control
1. Disabled
The OEM alarm will not be controlled by the interface upon remote start. No disarm or arm command will be
executed at the beginning or end of the sequence; it must be controlled by the Remote Starter.
2. Safelock
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote starter. It will unlock at the
beginning of the sequence, and relock after start and shutdown.
3. Enabled*
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and rearm the vehicle in the
remote start sequence, only when required. Smart OEM Alarm Control will monitor the alarm and door lock
status to detect if the disarm or rearm is required. If the vehicle is unlocked or is not equipped with factory alarm,
the disarm/rearm will not be executed.