11
403.CHRYSLER20 1.05 2022 Dodge/Ram 2500 (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
1
Wait until the LED turns ON solid red.
Note: To skip the transponder programming and use convenience features only, press the
programming button 5 times within 10 seconds. Wait until the LED turns ON solid orange,
then proceed with step 2.
2
With ONLY one key inside the vehicle.
Within 5 seconds, press the PTS button twice to turn the ignition ON. The LED starts to
flash orange quickly. Turn the ignition OFF by pressing the PTS button once more.
Note: If the transponder programming was skipped, the LED turns ON solid orange for 3
seconds then shuts OFF when programming is done.
Note: If 2 keys are present, the module will program but will not Remote Start.
3
Cycle the ignition ON and OFF up to 10 times by pressing the PTS button twice, then once to
shut the ignition OFF.
4
When the LED starts flashing orange slowly, turn the ignition OFF, remove the module from
the vehicle, and reconnect it to your computer. The web site will automatically recognize that
you are moving onto the second phase of the programming sequence.
5
Click on Submit Key2GO Request.
6
Once the configuration is completed, reconnect the module. The LED turns ON solid green for
3 seconds, then turns OFF.
You have successfully completed the module programming sequence.