Type 8
Refer to "Pre-installation and application warnings" on page 4 for important information, such as the description of special notes referenced in the diagram (
).
16
8
9
1
Ignition Switch
(6-pin connector)
HS CAN Low: Tan: 4
HS CAN High: Tan/Black: 5
C-CAN High: pin 6
C-CAN Low: pin 14
FT CAN High: Orange/Green: 7
FT CAN Low: Orange/Brown: 8
9: Black: (-) Ground
10: Red: (+) 12V
(+) 12V
7 White
4 White
8 thick-gauge wir
es
MC501
B-CAN Wires & Parking Lights
Refer to the Vehicle wiring
reference charts for the
connector, pin and wire color
in your vehicle.
(+) Ignition Output:
Pink
(+) 12V Input: Red
(+) Accessory Output: Orange
(+) 12V Input: Red
(+) 12V: Red
pin 1
(+) Ignition:
Pink, pin 4
(+) Accessory:
Blue, pin 2
(+) Starter:
Green, pin 2
(+) Starter Output
(to starter): Violet
OBDII Diagnostic
(connector side view)
(-) Hood Input: Gray: 3
Hood Pin
Siren
The Remote Start
Safety Override
Switch MUST be in
the ON position.
Remote Start Safety
Override Switch
(+) Siren Output: Brown: 17
Starter Input (from
key switch): Green
(-) Parking Lights Output: Green/Black: 10
OR
2 - MC11, Yellow 24-pin connector
7
1 - MC41, Blue 15-pin connector
11: Orange/Yellow:
Immobilizer Data Interrupt
(connector side)
6: Yellow:
Immobilizer Data Interrupt
(vehicle side)
Immo. Data Interrupt (connector side): Orange/Black: 3
Immo. Data Interrupt (vehicle side): Yellow/Black: 2
Connector
EMS COM connections are only needed
if the vehicle has a transponder/immobilizer.
Refer to the Vehicle wiring reference chart section for
the connector, pin and wire color in your specific vehicle.
Cut
1
2
3
4
5
6
7
8
15 14
13
12
11
10 9
DO NOT USE
Blue: pin 8
Larger 20 AWG
USE
Blue: pin 1
22 AWG
C-CAN wires MUST be
connected for proper
operation.
33
Directed Digital Solutions HKHT1
© 2020-03-03 Directed. All rights reserved.
